Release Notes/Solved items Version 2021.2.8

RadiMation version 2021.2.8

• #3971: Radiated emission multiband: click on "continuous measure" to disable function is taken twice quite often.
• #6698: Project: Improve Continuous measurement method.
• #11553: Underscore shortcut keys are not correctly assigned in field probe setup dialog
• #11604: Text that is shown in progress bar is dark grey, instead of black as in buttons.
• #11612: Binary block buffer retrieval over VISA Socket port is resulting in timeout
• #11687: WriteReadBinaryBlockBuffer causes timeout when TCPIP::x.x.x.x::port::SOCKET is used
• #11742: ErrorReport: "locked the gpib board".
• #11887: Measure time of 10ms is out of range.
• #12053: The device driver system is currently not usable
• #12072: ErrorReport: "Multiband Test one subrange not executed".
• #12082: Schwarzbeck CDN as injection device
• #12083: Include a check during startup to ensure that the Windows decimal separator is not "" (blank/nothing) or "0"
• #12084: Correction file with Frequency unit in kHz only shows half of the graph
• #12106: Send frequencies above 10 GHz to newer RadiSense 10 probes.
• #12108: Control channel selection of the radio dummy/fibre optic link of RFPA
• #12129: RepGen: Using a RunMacro keyword, results in the "" keyword not found event being presented
• #12133: Magnitude graph of S-parameter test shows an additional line going to 0
• #12134: Stop sequence: sequence is not correctly aborted when stop is pressed during a zero operation.
• #12135: Frequency scale is not full span.
• #12141: Resolution of R&S ESIB can be configured but only to 500 points
• #12142: Correction file: graph not displayed
• #12146: Rigol RSA5065A without EMI option can only measure a single trace
• #12160: Provide a configuration setting in the Narda EP600-series to configure the sleep mode time.
• #12173: Virtual Signal generator enables carrier on frequency change.
• #12174: Time-out Spurious emission measurement.
• #12181: Strange error on closing RadiPower driver.
• #12185: Rigol RSA5000 series, should allow to use 0 dB attenuation in combination with preamplifier
• #12186: Rigol RSA5065: When auto preamplifier is selected, it is reported as 0 dB, even though the preamplifier is on
• #12207: Reselect the limitline in the TSF file clears the max value customization of the graph.
• #12208: Driver: Tektronix RSA 306B.
• #12216: Error message that device driver system is not usable after a RadiSense error
• #12223: Driver: Prana IPDR250
• #12224: Driver: Prana CJDR250