Measurement Settings: Difference between revisions

Latest revision as of 13:13, 22 December 2015

Redirect to:

@@ Line 1: / Line 1: @@
-[[Image:Measurement Settings.PNG]]
+#REDIRECT [[Chapter_14#7._Measurement_Settings]]
-= Measurement settings =
-With measurement settings you can change the behaviour of the at certain points. Be very careful what you do with these setting.
-All settings done here are globally used inside RadiMation.
-== Starting level signal generator ==
-With the starting level signal generator you can define the level on which RadiMation is setting the signal generator on at the start of a immunity test.
-== Perform power delivery test after pause ==
-== Disable frequency zoom-in in emission test ==
-Disable frequency zoom-in in emission test can be used to decrees the measuring time by not trying to pin point the most accurate frequency. Some labs are
-{{Warning|Disabling the zoom-in in emmission test in combination with analysers is very likely to result in wrong measurement. }}
-== Calibration ==
-When using the calibration date for devices, you can specify the behaviour here. This may vary between a simple message untill stopping measurements being done.
-= Required environment settings =
-With the required environment settings you can force the test engineer to fill in specific environment settings. The first test done with a new EUT document requires the engineer to fill in the requested information. The second time a button will appear that will fill in the same information as the previous time.