DeviceDriverRadiSenseTab

The RadiSense tab can be used to configure the specific settings of the DeviceDriverRadiSenseTab.

Direction

If the field strength of a specific single axis or an isotropic value should be measured.

Band selection

Allows if the Low frequency band, High frequency band, or both frequency bands should be used for the electrical field strength measurement.

RadiSense Firmware Version

Allows to select the firmware version that is present in the RadiSense probe. This information is used to used version specific commands to control the RadiSense and which baudrate to use for serial communication (version 4.6.0 and below use 9k6, versions above 4.6.0 use 19k2).

Filter Setting

The filter that should be used during the measurements.

Automatically turn laser on

If this option is checked, the driver will automatically activate the laser when the device is being used.