RadiMation Error: 805306943

GPIB system driver error (EDVR): Too many ethernet connections

A RadiMation device driver is trying to control a GPIB device through a GPIB board. However an error is raised by the GPIB system driver that controls that GPIB board. The driver has detected that the there are too many connections to the GPIB Ethernet device.

National Instruments NI-488.2

This error corresponds to the National Instruments NI-488.2 error 0xE1060077.

This error occurs if your interface is a GPIB-ENET/1000 and you are attempting to open more simultaneous connections than the GPIB-ENET/1000 allows.

Solution

When a National Instruments GPIB board is used, the configuration of the GPIB board can be checked and changed in the NI-MAX software.

• Check if the GPIB Ethernet device is still present and available in the NI-MAX software.

General Purpose Industrial Bus: A communication system used to 'remote control' test and measurement equipment.