Difference between revisions of "ESL6 performed tests"

From RadiWiki
Jump to: navigation, search
Line 6: Line 6:
 
* Preamplifier: not tested, option (B22) was not included
 
* Preamplifier: not tested, option (B22) was not included
 
* Tracking generator: not tested, option was not included
 
* Tracking generator: not tested, option was not included
 +
* Communication over LAN: Ok
  
 
== Receiver mode ==
 
== Receiver mode ==
 
* RBW: NOT Ok
 
* RBW: NOT Ok
 
+
* Attenuator: 0, 5, 10, 15, 20, 25, 30, 35, 40, 45, 50 dB
 
 
 
* Initial scan: Peak, Peak + Average, Peak + Average + RMS, Peak + Average + RMS + QP
 
* Initial scan: Peak, Peak + Average, Peak + Average + RMS, Peak + Average + RMS + QP
 
* Final Measurement Peak Detector: Ok
 
* Final Measurement Peak Detector: Ok
Line 17: Line 17:
 
* Final Measurement RMS Detector: Ok
 
* Final Measurement RMS Detector: Ok
 
* Linear frequency mode: Ok
 
* Linear frequency mode: Ok
* Logarithmic frequency mode: NOT tested yet....
+
* Logarithmic frequency mode: Ok
 
+
* Measure time: Ok
 
== Analyser mode ==
 
== Analyser mode ==
 
* NOT tested yet...
 
* NOT tested yet...
 
* Point count: ....
 
* Point count: ....

Revision as of 14:53, 16 February 2012

The following tests has been performed on a R&S ESL6 to verify the functionality of the device driver

General

  • Model: Rohde & Schwarz ESL 6
  • Firmware version: 1.83 SP1
  • Preamplifier: not tested, option (B22) was not included
  • Tracking generator: not tested, option was not included
  • Communication over LAN: Ok

Receiver mode

  • RBW: NOT Ok
  • Attenuator: 0, 5, 10, 15, 20, 25, 30, 35, 40, 45, 50 dB
  • Initial scan: Peak, Peak + Average, Peak + Average + RMS, Peak + Average + RMS + QP
  • Final Measurement Peak Detector: Ok
  • Final Measurement QP Detector: Ok
  • Final Measurement AVG Detector: Ok
  • Final Measurement RMS Detector: Ok
  • Linear frequency mode: Ok
  • Logarithmic frequency mode: Ok
  • Measure time: Ok

Analyser mode

  • NOT tested yet...
  • Point count: ....