|
|
| (7 intermediate revisions by one other user not shown) |
| Line 1: |
Line 1: |
| − | The following tests has been performed on a R&S ESL6 to verify the functionality of the device driver
| + | #REDIRECT [[Rohde & Schwarz ESL 6]] |
| − | | |
| − | == General ==
| |
| − | * Model: Rohde & Schwarz ESL 6
| |
| − | * Firmware version: 1.83 SP1
| |
| − | * Preamplifier: not tested, option (B22) was not included
| |
| − | * Tracking generator: not tested, option was not included
| |
| − | * Communication over LAN: Ok
| |
| − | | |
| − | == Receiver mode ==
| |
| − | * RBW: NOT Ok
| |
| − | * Attenuator: 0, 5, 10, 15, 20, 25, 30, 35, 40, 45, 50 dB
| |
| − | * Initial scan: Peak, Peak + Average, Peak + Average + RMS, Peak + Average + RMS + QP
| |
| − | * Final Measurement Peak Detector: Ok
| |
| − | * Final Measurement QP Detector: Ok
| |
| − | * Final Measurement AVG Detector: Ok
| |
| − | * Final Measurement RMS Detector: Ok
| |
| − | * Linear frequency mode: Ok
| |
| − | * Logarithmic frequency mode: Ok
| |
| − | * Measure time: Ok
| |
| − | == Analyser mode ==
| |
| − | * NOT tested yet...
| |
| − | * Point count: ....
| |
