Difference between revisions of "Narda 3000-30"
(Initial DeviceDriverInfo page creation) |
(Updated DeviceDriverInfo template) |
||
Line 1: | Line 1: | ||
{{DeviceDriverInfo | {{DeviceDriverInfo | ||
− | |||
|DLLFile=RADCOUP.DLL | |DLLFile=RADCOUP.DLL | ||
|DeviceBrand=Narda | |DeviceBrand=Narda | ||
+ | |DeviceDriverName=NARDA3000-30 | ||
+ | |DeviceType=3000-30 | ||
|SupportedDeviceTypes=4 | |SupportedDeviceTypes=4 | ||
− | |||
}} | }} |
Latest revision as of 12:48, 21 June 2007
The Narda 3000-30 device driver is a Coupler which is supported by RadiMation®.
Configuration
The following tabs are available in the advanced configuration of the Narda 3000-30:
The frequency range of the Narda 3000-30 as provided by the manufacturer is shown and selected as default. It is possible to overrule these frequencies and to manual adjust the allowed frequency range of the Narda 3000-30.
Use default start frequency | If the checkbox is checked, the default start frequency will be used as the lowest usable frequency in a test for this device. |
Use default stop frequency | If the checkbox is checked, the default stop frequency will be used as the highest usable frequency in a test for this device. |
Specifying a different frequency range can be useful if for example:
- A device (like a coupler, antenna, injection device, cable, etc...) is still useable (but out of specification) outside the standard suggested frequency range.
- An external mixer is used to measure an extended frequency range.
- An up- or down-convertor is used to shift the frequency range.
- A newer model of a device is present that has an extended frequency range, and still uses the same remote control commands.
Be careful changing these setting as RadiMation® is no longer able to verify if the Narda 3000-30 is used outside frequency range that is specified by the manufacturer. This may result to serious damage of your measurement device.
Related pages
Links
- Google search: Narda 3000-30
- Google image search: Narda 3000-30
This information about an equipment is automatically generated from the list of supported device drivers from RadiMation. |
If you need more information you can contact radimation-support@raditeq.com. |