Raditeq EVO3: Difference between revisions
Jump to navigation
Jump to search
DevicesBot (talk | contribs) (Initial DeviceDriverInfo page creation) |
DevicesBot (talk | contribs) (Updated DeviceDriverInfo template) |
||
| (2 intermediate revisions by one other user not shown) | |||
| Line 4: | Line 4: | ||
|DeviceDriverName=EVO3 | |DeviceDriverName=EVO3 | ||
|DeviceType=EVO3 | |DeviceType=EVO3 | ||
|HideAutoData=1 | |||
|SupportedDeviceTypes=64 | |SupportedDeviceTypes=64 | ||
}} | }} | ||
== Channels == | |||
This device driver is providing the following named AD-convertor channels: | |||
* Measured frequency: The frequency (expressed in MHz) of the signal with the highest measured amplitude. | |||
* Measured amplitude: The amplitude of the signal with the highest measured amplitude. | |||
* Board temperature: The temperature (expressed in degrees Celsius) of the board. | |||
* CPU temperature: The temperature (expressed in degrees Celsius) of the CPU. | |||
* Scan time: The time (expressed in ms) that is needed for a single cycle of all the bands. | |||
If numbered channels are used, the following mapping is used: | |||
* Channel 1: Measured frequency. | |||
* Channel 2: Measured amplitude. | |||
* Channel 3: Board temperature. | |||
* Channel 4: CPU temperature. | |||
* Channel 5: Scan time. | |||
During the initialization of the EVO3, the internal Dallas-ID is also requested, and added to the General Information of the test. | |||
Latest revision as of 02:05, 20 February 2021
The Raditeq EVO3 device driver is a AD Converter which is supported by RadiMation®.
Channels[edit]
This device driver is providing the following named AD-convertor channels:
- Measured frequency: The frequency (expressed in MHz) of the signal with the highest measured amplitude.
- Measured amplitude: The amplitude of the signal with the highest measured amplitude.
- Board temperature: The temperature (expressed in degrees Celsius) of the board.
- CPU temperature: The temperature (expressed in degrees Celsius) of the CPU.
- Scan time: The time (expressed in ms) that is needed for a single cycle of all the bands.
If numbered channels are used, the following mapping is used:
- Channel 1: Measured frequency.
- Channel 2: Measured amplitude.
- Channel 3: Board temperature.
- Channel 4: CPU temperature.
- Channel 5: Scan time.
During the initialization of the EVO3, the internal Dallas-ID is also requested, and added to the General Information of the test.