Monitoring input channel setup: Difference between revisions
Jump to navigation
Jump to search
(Created page with 'Monitoring input channel setup') |
No edit summary |
||
| Line 1: | Line 1: | ||
Monitoring input channel setup | Monitoring input channel setup | ||
= General = | |||
This setting window enables the end-user to configure the used AD-Converter during the test. | |||
= Settings = | |||
* Description. Here can the description of the device entered. | |||
* Device. From the dropdown the used AD-Converter driver can be selected. | |||
* Channel. Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels. | |||
* Unit. Enter the unit corresponding to the values which will be retrieved from the device. | |||
= Calculation = | |||
= Measure = | |||
= Range = | |||
[[Category:RadiMation]] | |||
Revision as of 12:50, 16 October 2015
Monitoring input channel setup
General[edit]
This setting window enables the end-user to configure the used AD-Converter during the test.
Settings[edit]
- Description. Here can the description of the device entered.
- Device. From the dropdown the used AD-Converter driver can be selected.
- Channel. Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels.
- Unit. Enter the unit corresponding to the values which will be retrieved from the device.