Monitoring input channel setup: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 5: | Line 5: | ||
= Settings = | = Settings = | ||
{{ScreenElementDescription|Description | {{ScreenElementDescription|Description|Here can the description of the device entered.}} | ||
{{ScreenElementDescription|Device| From the dropdown the used AD-Converter driver can be selected.}} | |||
{{ScreenElementDescription|Channel| Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels.}} | |||
{{ScreenElementDescription|Unit| Enter the unit corresponding to the values which will be retrieved from the device.}} | |||
= Calculation = | = Calculation = | ||
Revision as of 12:53, 16 October 2015
Monitoring input channel setup
General[edit]
This setting window enables the end-user to configure the used AD-Converter during the test.
Settings[edit]
 Description
|
Here can the description of the device entered. |
| Device
|
From the dropdown the used AD-Converter driver can be selected. |
| Channel
|
Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels. |
| Unit
|
Enter the unit corresponding to the values which will be retrieved from the device. |