Cable Calibration

Because this type of test considered to be a calibration all eut windows must be closed.

    Calibration

       System Calibration

          Attenuation / Gain

Frequency Range

Sets the frequency specification to a frequency range.

Start

Sets start frequency.

End	Sets end frequency.

Step Fixed

Sets a fixed step size from start to end frequency.

Step Previous Frequency

Sets a logarithmic step size from start to stop frequency

Starting From

Sets the start frequency for a logarithmic step from which the actual measurement frequencies will be calculated. the starting from frequency should be lower then the actual start frequency. The test will start at the first calculated frequency that is equal or higher then the specified start frequency.

Frequency list

With frequency list the operator can select a frequency list file by browsing to the file location. The frequencies inside the frequency list file will be measured.

Signal Power

Signal power

The setting of the signal power level during the test.

Power Meter

Amount of samples

The amount of samples level during the test.

Test equipment

In the test site window the test engineer can select which equipment list will be used during this test.

Test engineer

In the test engineer window, the test engineer can select its own name. The test engineer name will be stored by the test results.

Equipment icon

By clicking on the equipment icon, the equipment list can be viewed and edited.