Monitoring input channel setup

Monitoring input channel setup

Warning:

This page is a draft

General

The Monitoring input channel setup window can be opened by opening a new or existing EUT file:

    File

       Open

          EUT or

    File

       New

          EUT

Then select the 'Monitoring input channels' panel. This window enables the end-user to configure the used AD-Converter during the test:

Settings

Description

Enter the description of the device. E.g. use the brand and/or identification number.

Device

From the dropdown the used AD-Converter driver can be selected.

Channel

Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices are still be limited to support a maximum of eight channels in this list, while their driver supports more channels.

Unit	Enter the unit corresponding to the values which will be retrieved from the device.

Calculation

None	RadiMation will not apply any additional calculations to the value the device driver is returning.

Offset

RadiMation will additionally apply the specified offset to the retrieved value by the device driver. Similar to the formula (offset+x).

Multiply

RadiMation will additionally apply the specified multiply factor to the retrieved value by the device driver. Similar to the formula (factor*x).

AD input range

RadiMation will not apply any additional calculations to the value the device driver is returning.

Formula y(x)

RadiMation will additionally apply the specified formula to the retrieved value by the device driver.

It is needed to match the expected value with the retrieved value by the device driver. Especially for older device driver it is needed to specify the allowed value range of the device.

Range

Enable Min Range

This will show a graph line of the specified minimum in the graph and table.

Enable Max Range

This will show a graph line of the specified maximum in the graph and table.

Equipment Under Test

Analog to Digital