Configurable XYZ Positioner

From RadiWiki
Revision as of 11:48, 11 February 2020 by DevicesBot (talk | contribs) (Updated DeviceDriverInfo template)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

The Configurable XYZ Positioner device driver is a Positioner which is supported by RadiMation®.  

Configurable XYZ Positioner[edit]

This driver can be configured to send commands to an EUT X, Y and Z-axis Positioner. It will be used in a Radiated Emission test with the location type GTEM configured. Below an overview of the commands to configure:

Configurable XYZ Positioner.PNG

Initialisation and Check[edit]

ScreenElementDescription.svg Reset The reset command sent during the initialisation phase
ScreenElementDescription.svg Init The command sent during the initialisation phase
ScreenElementDescription.svg Get ID The command sent to request the identifier of the device, e.g. *IDN?
ScreenElementDescription.svg Returned ID The response of GET ID, this can either be the returned value or an regular expression
ScreenElementDescription.svg Deinit The command sent during the de-initialisation phase
ScreenElementDescription.svg Wait for Completion after sending command With this command the configured commands below will also send an *OPC? command to query if the operation is completed

XYZ Positioner[edit]

ScreenElementDescription.svg X Position The command which will start to move the EUT in the X Position
ScreenElementDescription.svg X Position Stop The command which will be sent after "X Position" command is sent and the configured waiting time is elapsed
ScreenElementDescription.svg Y Position The command which will start to move the EUT in the Y Position
ScreenElementDescription.svg Y Position Stop The command which will be sent after "Y Position" command is sent and the configured waiting time is elapsed
ScreenElementDescription.svg Z Position The command which will start to move the EUT in the Z Position
ScreenElementDescription.svg Z Position Stop The command which will be sent after "Z Position" command is sent and the configured waiting time is elapsed
ScreenElementDescription.svg Waiting time The time to wait between the '...'-Position and '...'-Position Stop. Specified in milliseconds (ms). This waiting time is only used when the start command is configured.