Talk:RadiMation Application Note 106

From RadiWiki
Revision as of 13:16, 27 October 2020 by Joro (talk | contribs) (→‎Image)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Goal

To explain how the parameters of the powermeter configuration can be used to retrieve stable powermeter readings

Todo

  1. V Include a screenshot of the powermeter parameter settings
  2. V Explain the purpose of the possible parameters
  3. V Explain the different between levelling and monitoring
  4. V Explain tips and tricks on how to determine better measurement parameters
  5. V Explain that the change is caused by the slowness of the powermeter but also by the slowness of the signal generator
  6. ? Include a picture of the Marconi power change when the carrier is changed, measured using the radipower envelope mode.
  7. V * Do a levelling test. Signal generator carrier going up and down a lot? => Too fast. Slow it down
  8. V * Slow measurements => Make it faster, but check (see at previous point) that it is not too fast
  9. * Use the device specific input measurement to get 'internal' information of the levelling measurement in the powermeter

discussion

  • Should we also handle the same information for the fieldstrength sensor in the same application note, or should we create a separate application note for almost the same information for the fieldstrength sensor?

Image

An image seems to be present that shows a changing input, and the measured values.

See:

MeasureLoop.png

However that file is not used in this applicatin note.