Release Notes/Solved items Version 5.8

RadiMation version 5.8.2[edit]

#2152: Peak search for turntable angle should be configurable to include another angle range than the configured turntable
#2153: Peak search for antenna tower height should be configurable to include another height range than the configured antennatower
#2843: Incrementing the turntable angle, should wrap to the corresponding value if the maximum angle is reached
#2849: When the turntable angle is changed, the direction with the shortest angle difference should be used to turn the turntable
#3545: Automatic Angle and Height optimization should use the physical limitations of the turntable and antenna tower
#3592: Turn Table Action in Manual Mode not possible with EMCO 1050
#3593: Antenna Tower Action in Manual Mode not possible with EMCO 1050
#3755: RadiMation is setting up the ESPI with incorrect RBW during CI-testing

#3201: Dificulties with OATS measurements
#3563: Limit lines should be shown in polar plot and height graph
#3701: Multiband Radiated Emission: Default value in dropdown list for Turntable Angle specifies 235°
#3744: When 'Detect Peaks' is pressed, already detected peaks should be placed on the angle/height with the maximum emission
#3745: Turntable doesn't turn a complete turn when it starts on a negative angle
#3746: Peak zoom-in doesn't seem to work in multiband emission
#3747: Improve peak detection by splitting the span in chunks
#3748: Improve EMCO1060 turntable controller
#3749: Click on the graph to add peak, should allow multiple peaks on the same frequency but with a different polarization
#3751: Frequency marker is not moved on the graph when it is dragged
#3752: Clicking on the turntable CW button to release it again doesn't respond
#3753: HP4395A is always using 10 Hz RBW when it is used for a voltage measurement
#3754: Climate chamber is not controlled correctly by RadiMation.

#1713: Continuous scanning is not possible in Multiband Emission Manual mode
#2512: Zooming into emission graph while measurement still running
#2597: In multiband immunity the cancel button only reacts on the end of the dwelltime
#3203: Manual mast control does not work correctly, Up is not always Up
#3386: the Radisense ctr1001B driver does not allow you to set the filter when using in gpib mode.
#3490: Multi band emission manual mode is generating error when selecting the test site
#3456: Manual mode multiband emission test does not have an initial graph which results in a crash
#3547: First graph in a multiband emission measurements shows a bottom y-axis value of -1000 dBuV/m
#3552: Spurious peaks in polar plot as a result of the initial measurement
#3566: Change the frequency/angle/height of a detected peak by moving the marker in the graph
#3611: Turning range of the antenna tower when changing polarization
#3709: zero-span mode in radiated emission multiband
#3714: Emission Multiband: Scan analysis while scan is running
#3720: During emission test: crosses instead of line
#3724: Radisense 4 over RS232 does not set the filter setting
#3729: CE multi band measurement is not showing the information below 1 MHz
#3736: I can not select apply modulation outside dwell time when selecting pulse