Talk:RadiMation Application Note 106

Goal

To explain how the parameters of the powermeter configuration can be used to retrieve stable powermeter readings

Todo

1. Include a screenshot of the powermeter parameter settings
2. Explain the purpose of the possible parameters
3. Explain the different between levelling and monitoring
4. Explain tips and tricks on how to determine better measurement parameters
5. Explain that the change is caused by the slowness of the powermeter but also by the slowness of the signal generator
6. Include a picture of the Marconi power change when the carrier is changed, measured using the radipower envelope mode.
   • Do a levelling test. Signal generator carrier going up and down a lot? => Too fast. Slow it down
   • Slow measurements => Make it faster, but check (see at previous point) that it is not too fast
   • Use the device specific input measurement to get 'internal' information of the levelling measurement in the powermeter

discussion

• Should we also handle the same information for the fieldstrength sensor in the same application note, or should we create a separate application note for almost the same information for the fieldstrength sensor?