RadiMation Application Note 135

How to program the RadiSense 10 Calibration table

This RadiMation^® application note explains how RadiMation^® can be used to program the calibration data in a RadiSense 10 field probe.

Note:

Any other correction file for the probe device driver settings should not be applied as well, as it will trigger a double correction!

Creating the correction file

1. Create a RadiMation correction file, by selecting from the menu:

    File

       New

          Correction .

1. Press Columns/Units to open the column selector
2. Add the Frequency, X-axis correction, Y-axis correction and Z-axis correction columns.
   
3. Paste the earlier determined correction values from Excel into the correction file.
   Note. Multiple columns can be pasted from excel into a correction file with a single operation.
   Note. If the first row in the table seen in the correction file is not overwritten, remove this row.
   
4. Store the correction file.

Uploading the correction file

1. Go to the "advanced settings" of the RadiSense device driver and select User Calibration".
   
2. Click Browse. Then find and select the earlier created correction file. Then click Program calibration table.
3. When the progress bar is at 100% the programming has been succesfully completed.

Using the probe in a test

1. Go to the "advanced settings" of the RadiSense device driver and select User Calibration".
   
2. Make sure to check the checkbox “Use calibration if available” if the calibration should be used.

Conclusion

By following the steps that are explained in this RadiMation^® application note, it is possible to program the calibration data into a RadiSense 10 field probe. This has the advantage that all the individual axis are corrected with their own calibration data in the probe itself. Also the isotropic field value is then optimally corrected, and will result in a more accurate measurement.