Configurable Modulation Source
Jump to navigation
Jump to search
 Reset
|
Command to be send to the device to reset the device. Leave blank if you do not want to reset the device. |
| Init
|
Command to be send to the device to initialize the device. Leave blank if you do not want to initialize the device. |
| Get ID
|
Command to be send to the device to get the identification from the device. Leave blank if you do not want to verify if the device is connected. If you do not use the verify, RadiMation® will not raise an error when a device is not connected during the initialization of a test. |
| Returned ID
|
The complete or a part of the return string from the device. The string is compared and when found the check will return that the device is connected. |
| Carrier Level
|
The command that is send to the device to set the level. Because the command can contain more then just the value that needs to be send, a indicator is used. The indicator for the level is the code __carrier__.
Example: LEVEL __carrier__ V. and the level that needs to be send is 2 V. Will result in LEVEL 2 V |
| Carrier On
|
The command that is send to turn on the carrier of the modulator. |
| Carrier Off
|
The command that is send to turn off the carrier of the modulator. |
| Frequency
|
The command that is send to the device to set the frequency. Because the command can contain more then just the value that needs to be send, a indicator is used. The indicator for the level is the code __freq__.
Example: FREQ:CW __freq__ HZ. and the frequency that needs to be send is 200 Hz. Will result in FREQ:CW 200 HZ. |
| Sinus
|
The command that is send to the device to set the signal type to sinus. |
| Square
|
The command that is send to the device to set the signal type to square. |
| Triangle
|
The command that is send to the device to set the signal type to triangle. |