User:Jewe

1. make new getting started

Signal generator driver test

The following settings need to be tested:

Normal operation mode

1. Amplitude
2. Frequency
3. AM, 80% 1 kHz
4. FM
5. PM 50% 1 KHz.
6. AM external.
7. FM external.
8. PM external.
9. Sine wave for amplitude modulation
10. Square wave for amplitude modulation

Note:

All modulations needs to tested with a scope if the signal generator does not allow the settings to be read from the display.

Error operation mode

1. unplug the communication cable during testing
2. Set the AM to out of boundary settings, for example 0% or 1 MHz, this is not supported by the machine.
3. Set the FM to out of boundary settings, for example 1 Hz or 1 MHz, this is not supported by the machine.
4. Set the PM to out of boundary settings, for example 0,1 Hz and 1%.

Note:

With all out of boundary settings an error must be generated.