ESL6 performed tests
The following tests has been performed on a R&S ESL6 to verify the functionality of the device driver
General
- Model: Rohde & Schwarz ESL 6
- Firmware version: 1.83 SP1
- Preamplifier: not tested, option (B22) was not included
- Tracking generator: not tested, option was not included
- Communication over LAN: Ok
Receiver mode
- RBW: NOT Ok
- Attenuator: 0, 5, 10, 15, 20, 25, 30, 35, 40, 45, 50 dB
- Initial scan: Peak, Peak + Average, Peak + Average + RMS, Peak + Average + RMS + QP
- Final Measurement Peak Detector: Ok
- Final Measurement QP Detector: Ok
- Final Measurement AVG Detector: Ok
- Final Measurement RMS Detector: Ok
- Linear frequency mode: Ok
- Logarithmic frequency mode: Ok
- Measure time: Ok
Analyser mode
- RBW: Not tested yet...
- Reference Level: Ok
- Attenuator: 0, 5, 10, 15, 20, 25, 30, 35, 40, 45, 50 dB
- Sweeptime: Ok
- VBW: Ok
- Initial scan: Peak, Peak + Average, Peak + Average + RMS, Peak + Average + RMS + QP
- Point count: 101 to 32001
- Final Measurement Peak Detector: Ok?
- Final Measurement QP Detector: Ok?
- Final Measurement AVG Detector: Ok?
- Final Measurement RMS Detector: Ok?
