Release Notes/Solved items Version 2013.1.18

RadiMation version 2013.1.18[edit]

#1368: Use blanking input for SMY02 PM modulation
#4062: R&S SMY-01 input blanking for pulse modulation
#4255: Driver: strange VBW value is set
#4256: Calibration asks for resistor and shows voltage level
#4260: Measuring deviations despite correct .CAL
#4267: Starting Level Signal Power can trigger RF power on without interlock
#4273: Power meter is read continuously with modulation applied in Manual Mode
#4547: Setting the reference level has no effect on the ESMI
#4548: Can select only one peak at the time
#4592: Powermeter virtual instrument is not always unloaded from memory
#4616: MXE alignment issue and is not released from remote
#4842: Graph lines from a previous VI Powermeter window are still shown under the 'Graphs' button
#4932: Driver: Injection device FCC F51
#4992: Configure a maximum of 360 degrees for a Manual Controlled Turn Table
#4995: Customization of the Graphline color in the Powermeter window is not working
#5008: Dropdown of the threshold level for a burst test is using an unlogical order
#5022: Innco CO3000 is started at 100cm instead of 90cm
#5037: RG error when requesting the Equipment Table information
#5047: Pulsed Immunity explanation
#5054: Mil Std CAL text is not completely visible
#5059: Innco CO3000 control multiple devices with one GPIB address without addressing
#5064: 18-channel AD-convertor device driver for the RadiSense to be used during justation
#5067: Agilent 8753ES can't change GPIB address