RadiMation Error: 805306894

Not all bytes are written to the GPIB-Board within the timeout period (GPIB:EABO)

During a write operation to a GPIB device, not all the data could be written to the GPIB device.

Solution

Possible reasons for this error can be:

• The GPIB device is not available on the specified GPIB address. Check the selected GPIB address in the device driver configuration
• The GPIB device is suddenly turned off
• The GPIB device has detected an error, and is not correctly communicating on the GPIB bus.

If this problem remains after manually checking the above options, further investigation by DARE!! Instruments is necessary to find the real cause of this problem.

General Purpose Industrial Bus: A communication system used to 'remote control' test and measurement equipment.