Advanced turn table settings

Question

Can I set the start and stop position of the turn table before and after a test?

Answer

Yes, you can by setting some additional keys in the ini file.

• TurnToAtStart is the starting point of the test. so even if you are doing a test from 180 to 270 it will first goto 0 degrease.
• TurnToAtStop is the final point after the test.

• TurnAtStop is for turning the possibility on and off to turn to a position. 1 equals on and 0 equals off.
• TurnAtStart is for turning the possibility on and off to turn to a position. 1 equals on and 0 equals off.

Note:

If the keys are not there then add them when needed

Example 1

Set the turn table to go to 90 degrease as starting point and stop point at 270. Turn table used is the 2090

[EMCO2090]
TurnAtStart=1 
TurnToAtStart=90
TurnAtStop=1
TurnToAtStop=270

Example 2

Do nothing with turn table default. Turn table used is the 2090

[EMCO2090]
TurnAtStart=0 
TurnToAtStart=90
TurnAtStop=0
TurnToAtStop=270

As you can see we have changed the values for the TurnAtStart and the TurnAtStop.