Em test CWS500N1.1
Revision as of 12:14, 3 April 2020 by DevicesBot (talk | contribs) (Updated DeviceDriverInfo template)
The em test CWS500N1.1 device driver is a Coupler which is supported by RadiMation®.
Configuration
The following tabs are available in the advanced configuration of the Em test CWS500N1.1:
The frequency range of the Em test CWS500N1.1 as provided by the manufacturer is shown and selected as default. It is possible to overrule these frequencies and to manual adjust the allowed frequency range of the Em test CWS500N1.1.
![]() |
If the checkbox is checked, the default start frequency will be used as the lowest usable frequency in a test for this device. |
![]() |
If the checkbox is checked, the default stop frequency will be used as the highest usable frequency in a test for this device. |
Specifying a different frequency range can be useful if for example:
- A device (like a coupler, antenna, injection device, cable, etc...) is still useable (but out of specification) outside the standard suggested frequency range.
- An external mixer is used to measure an extended frequency range.
- An up- or down-convertor is used to shift the frequency range.
- A newer model of a device is present that has an extended frequency range, and still uses the same remote control commands.
Be careful changing these setting as RadiMation® is no longer able to verify if the Em test CWS500N1.1 is used outside frequency range that is specified by the manufacturer. This may result to serious damage of your measurement device.
Links
- Google search: em test CWS500N1.1
- Google image search: em test CWS500N1.1
This information about an equipment is automatically generated from the list of supported device drivers from RadiMation. |
If you need more information you can contact radimation-support@raditeq.com. |