Vector network analyser

Vector Network Analysers

VNA's allow you to measure complex quantities such as reflection coefficients, impedance, admittance, return loss, insertion loss, gain, isolation of an DUT.
A VNA has both a source and a set of receivers used to determine changes to the stimulus caused by the DUT.
The stimulus-based test approach allows VNAs to measure very small reflections and changes to the stimulus enabling you to accurately characterize any RF component in real-world environment and test conditions(1).

Types of measurement

Vector Network Analyzer’s perform two types of measurements – transmission and reflection.
Transmission measurements pass the Vector Network Analyzer stimulus signal through the device under test, which is then measured by the Vector Network Analyzer receivers on the other side.
Reflection measurement measures the signal that travels back towards the source due to reflections(2).

The image(2) seen below further illustrates this concept.

Sources

(1)https://www.tek.com/vna/ttr500
(2)https://www.tek.com/document/primer/what-vector-network-analyzer-and-how-does-it-work

Device Under Test. This is equivalent to the term EUT (Equipment Under Test). RadiMation^® always uses the term EUT.

Radio Frequency