Measurement Settings

Measurement settings

With measurement settings you can change the behaviour of the at certain points. Be very careful what you do with these setting.

All settings done here are globally used inside RadiMation.

Starting level signal generator

With the starting level signal generator you can define the level on which RadiMation is setting the signal generator on at the start of a immunity test.

Disable frequency zoom-in in emission test

Disable frequency zoom-in in emission test can be used to decrees the measuring time by not trying to pin point the most accurate frequency. Some labs are

Warning:

Disabling the zoom-in in emmission test in combination with analysers is very likely to result in wrong measurement.

Calibration

When using the calibration date for devices, you can specify the behaviour here. This may vary between a simple message untill stopping measurements being done.

Required environment settings

With the required environment settings you can force the test engineer to fill in specific environment settings. The first test done with a new EUT document requires the engineer to fill in the requested information. The second time a button will appear that will fill in the same information as the previous time.

The ability of an EUT to be immune to incoming electromagnetic interference. This is equivalent to the term susceptibility that is used by some standards.

Equipment Under Test