RadiMation Application Note 157

How to perform a MIL-STD-461 RS103, radiated susceptibility, electric field

This application note explains how the MIL-STD-461 RS103, radiated susceptibility, electric field test can be performed with RadiMation^®

The exact requirements and test methods for the RS103 are specified in the MIL-STD-461.

Necessary equipment

The following devices are necessary to perform the CS109 test:

• Signal generator
• Amplifier
• Antenna
• Field probe

Define the test level

Create a correction file for the test level

    File

       New

          Correction

First create a correction file in RadiMation^® and specify the test level (See 'Table XI RS103 limits.').

    File

       Save correction

Store the test level as correction file on disk.

This correction file with the test level will be used during EUT testing.

EUT Testing

EUT Testing equipment

The configuration of the eut test site should contain the following devices:

#	Device name	Tab in testsite configuration window	note
	Signal Generator	Devices 1	The signal generator to use
	Amplifier	Devices 1	The amplifier to use
	Field Sensor 1	Field probes	The field sensor to use

Configure the EUT test

To perform the test on the EUT, create a radiated immunity multiband test. The radiated immunity multiband test, can be started by selecting from the menu:

    Tests

       Radiated Immunity

          Multiband

Start

The start frequency of the test. For example 2 MHz.

End	The stop frequency of the test. For example 30 MHz.

Frequency Step

The frequency step, see Table III.

Dwell Time

The dwell time.

Frequency Change Mode

Constant.

Modulation

The modulation to use see below.

Test equipment

The equipment needed for the radiated susceptibility test.

Location Type

Injection clamp.

Test Level

Specify the Electrical field closed loop method test level. Also configured a "Variable field"

Inputs

No inputs are needed.

At TestLevel click Add to add a new Test level and select TestLevel - Electrical field closed loop method

Description

The description of the test level.

Test level

Variable field, and specify the correction file for the applicable test level. When the level is one value this value can be specified with Constant field

Tolerance

Specify the tolerance to use.

Probes

Check Probe 1 to measure with the first probe.

When all settings are configured press Start Test to run the test.

The sensitivity of an EUT to incoming electromagnetic interference. This is equivalent to the term Immunity. RadiMation® always uses the term Immunity.

Equipment Under Test

The ability of an EUT to be immune to incoming electromagnetic interference. This is equivalent to the term susceptibility that is used by some standards.

The ability of an EUT to be immune to incoming electromagnetic interference. This is equivalent to the term susceptibility that is used by some standards.