Amplifier Protection
Contents
Amplifier protection
Introduction
RadiMation® has an build in Amplifier protection that will limit the power of the controlled signal generator. By default, the signal power is limited 0dBm to the amplifier input. By default, the signal power can also not exeed 20dBm.
The protection limit can be overwritten by adding correction to the Amplifier protection files section of the Amplifier device driver.
A new correction file can be created that only contains the column "Correction". Then this correction should be applied to the maximum frequency range of 1 Hz to 120GHz.
The correction can then be added to the Amplifier protection files. If no correction files are specified, the signal power is limited to the 0dBm. Adding the +40 correction, allows the signal power to go up to +40dBm, and then is limited by the default signal power limit of 20dBm.
If adding a correction to the maximum forward and/or maximum reflected , the signal power is limited by the measured forward and/or reflected power.
When this power is reached, This function can save a test engineer a lot of time, since the Report Generator only needs a few minutes to generate a complete test report. These test reports can be written in Microsoft Word, Microsoft Excel or Text format.
The basic information needed to create to generate a test report, as well as the more specific features of the Report Generator, are explained in the following paragraphs.
About the Report Generator
Template files and Report files
The Report Generator uses two files to generate a report; the Template file and the Report file.
