Difference between revisions of "CANoe"
(→CAPL) |
(→CAPL) |
||
| Line 10: | Line 10: | ||
*Power | *Power | ||
| − | |||
| + | To connect with RadiMation you need to configure the following things: | ||
| + | # Setting up the Canoe switch device. | ||
| + | # inserting the RadiMationInterface.can file inside your CANoe/CANalyser project. | ||
| + | |||
| + | you can extend the function inside the [[RadiMationInterface.can]] to you need. | ||
| + | Note that the function do not support a call back to the RadiMation application. | ||
| + | |||
| + | '''Note:''' You can't find out if a CAPL function exist with CANoe/CANalyzer COM server. | ||
When the function not exist the call will go in CANoe but there will come up no error message or return value. | When the function not exist the call will go in CANoe but there will come up no error message or return value. | ||
Revision as of 08:43, 20 July 2007
CANoe from [Vector] is used for reading out the CAN or LIN bus.
RadiMation connects through COM to this application
CAPL
CANoe supports CAPL, a programming interface. Through this interface RadiMation can send information back the Canoe software. For Example:
- Frequency
- Field Strength
- Power
To connect with RadiMation you need to configure the following things:
- Setting up the Canoe switch device.
- inserting the RadiMationInterface.can file inside your CANoe/CANalyser project.
you can extend the function inside the RadiMationInterface.can to you need. Note that the function do not support a call back to the RadiMation application.
Note: You can't find out if a CAPL function exist with CANoe/CANalyzer COM server. When the function not exist the call will go in CANoe but there will come up no error message or return value.
