Difference between revisions of "Configurable Modulation Source"
| Line 1: | Line 1: | ||
=Configurable Modulation Source= | =Configurable Modulation Source= | ||
[[Image:Configurable Modulation Source Init and Check tab.png]] | [[Image:Configurable Modulation Source Init and Check tab.png]] | ||
| − | |||
{{ScreenElementDescription|Reset|Command to be send to the device to reset the device. Leave blank if you do not want to reset the device.}} | {{ScreenElementDescription|Reset|Command to be send to the device to reset the device. Leave blank if you do not want to reset the device.}} | ||
{{ScreenElementDescription|Init|Command to be send to the device to initialize the device. Leave blank if you do not want to initialize the device.}} | {{ScreenElementDescription|Init|Command to be send to the device to initialize the device. Leave blank if you do not want to initialize the device.}} | ||
| Line 8: | Line 7: | ||
[[Image:Configurable Modulation Source Carrier tab.png]] | [[Image:Configurable Modulation Source Carrier tab.png]] | ||
| + | {{ScreenElementDescription|Carrier Level|The command that is send to the device to set the level. Because the command can contain maar then just the value that needs to be send, a indicator is used. The indicator for the level is the code __level__. | ||
| + | |||
| + | Example: LEVEL __level__ V. and the level that needs to be send is 2 V. | ||
| + | Will result in LEVEL 2V | ||
| + | }} | ||
[[Image:Configurable Modulation Source Waveform tab.png]] | [[Image:Configurable Modulation Source Waveform tab.png]] | ||
Revision as of 12:18, 21 August 2009
Configurable Modulation Source
 Reset
|
Command to be send to the device to reset the device. Leave blank if you do not want to reset the device. |
| Init
|
Command to be send to the device to initialize the device. Leave blank if you do not want to initialize the device. |
| Get ID
|
Command to be send to the device to get the identification from the device. Leave blank if you do not want to verify if the device is connected. If you do not use the verify, RadiMation® will not raise an error when a device is not connected during the initialization of a test. |
| Returned ID
|
The complete or a part of the return string from the device. The string is compared and when found the check will return that the device is connected. |
| Carrier Level
|
The command that is send to the device to set the level. Because the command can contain maar then just the value that needs to be send, a indicator is used. The indicator for the level is the code __level__.
Example: LEVEL __level__ V. and the level that needs to be send is 2 V. Will result in LEVEL 2V |
