Difference between revisions of "EMCO 5390 XYZ Positioner"

Revision as of 10:02, 22 January 2024

The EMCO 5390 XYZ Positioner can be setup to a certain preset for the X, Y or Z position.

X position

The preset to move to the X position

Y postion

The preset to move to the Y position

Z position

The preset to move to the Z position

Wait time after command

The time to wait for the positioner to move

The EMCO 5390 XYZ Positioner device driver is a Positioner which is supported by RadiMation^®.

This information about an equipment is automatically generated from the list of supported device drivers from RadiMation.

If you need more information you can contact radimation-support@raditeq.com.

Revision as of 10:00, 22 January 2024 (view source) Roge (talk \| contribs) ← Older edit		Revision as of 10:02, 22 January 2024 (view source) Roge (talk \| contribs) (→‎EMCO 5390 Configuration) Newer edit →
Line 1:		Line 1:
−	== EMCO 5390 ~~Configuration~~ ==	+	== Configuration of the EMCO 5390 ==
	The EMCO 5390 XYZ Positioner can be setup to a certain preset for the X, Y or Z position.		The EMCO 5390 XYZ Positioner can be setup to a certain preset for the X, Y or Z position.