Hameg 8130

General

Hameg was a German company that supplied EMC test houses and has now been integrated in the test and measurement division of Rohde & Schwarz

They delivered a wide portfolio of equipment that can be used for EMC measurements.

• List of supported equipment

Links

• Website: http://www.rohde-schwarz.com/
• Customer support:
  • E-mail: mailto:customersupport@rohde-schwarz.com
  • Telephone: +49 180 512 4242
• Wikipedia: Hameg

The Hameg 8130 device driver is a Signal Generator which is supported by RadiMation^®.

Configuration

The following tabs are available in the advanced configuration of the Hameg 8130:

The frequency range of the Hameg 8130 as provided by the manufacturer is shown and selected as default. It is possible to overrule these frequencies and to manual adjust the allowed frequency range of the Hameg 8130.

Use default start frequency

If the checkbox is checked, the default start frequency will be used as the lowest usable frequency in a test for this device.

Custom start frequency

If the Use default start frequency checkbox is unchecked, another start frequency (expressed in MHz) can be specified. The customized start frequency will then be used as the lowest usable frequency in a test for this device. The customized frequency can be a limitation or an extension of the default start frequency.

Use default stop frequency

If the checkbox is checked, the default stop frequency will be used as the highest usable frequency in a test for this device.

Custom stop frequency

If the Use default stop frequency checkbox is unchecked, another stop frequency (expressed in MHz) can be specified. The customized stop frequency will then be used as the highest usable frequency in a test for this device. The customized frequency can be a limitation or an extension of the default stop frequency.

Specifying a different frequency range can be useful if for example:

• A device (like a coupler, antenna, injection device, cable, etc...) is still useable (but out of specification) outside the standard suggested frequency range.
• An external mixer is used to measure an extended frequency range.
• An up- or down-convertor is used to shift the frequency range.
• A newer model of a device is present that has an extended frequency range, and still uses the same remote control commands.

Be careful changing these setting as RadiMation^® is no longer able to verify if the Hameg 8130 is used outside frequency range that is specified by the manufacturer. This may result to serious damage of your measurement device.

Related pages

• Hameg

Links

• Google search: Hameg 8130
• Google image search: Hameg 8130

This information about an equipment is automatically generated from the list of supported device drivers from RadiMation.

If you need more information you can contact radimation-support@raditeq.com.