Hameg 8130
The Hameg 8130 device driver is a Signal Generator which is supported by RadiMation®.
Connection methods
USB
The Hameg signal generator can be controlled by RadiMation® by USB connection. This does require the installation of a specific windows driver provided by Rohde & Schwarz.
Note the following when setting up to control the Hameg 8130 by USB:
The device comes available as a separate 'HAMEG Measurement Devices' category in the Windows Device manager. It is necessary to enable the 'Load VCP' option of the driver in the Windows Device manager. Then reconnect the USB again, and load the additional USB drivers.
Windows 11 support
The Windows USB driver provided by Rohde & Schwarz are not supported on Microsoft Windows 11 and newer. As an alternative the driver can be controlled using the hardware RS232 communication port of the Hameg 8130.
RS-232
The following communication settings can be used:
Baudrate: 4800
Data bits: 8
Parity: None
Stop bits: 1