Difference between revisions of "Hameg communication"
(→RS-232) |
(→USB) |
||
| Line 4: | Line 4: | ||
== Conection methods == | == Conection methods == | ||
==== USB ==== | ==== USB ==== | ||
| + | The Hameg signal generator can be controlled by RadiMation by USB connection. | ||
| + | |||
Note the following when setting up to control the Hameg by USB: | Note the following when setting up to control the Hameg by USB: | ||
| Line 9: | Line 11: | ||
It is necessary to enable the 'Load VCP' option of the driver in the Windows Device manager. | It is necessary to enable the 'Load VCP' option of the driver in the Windows Device manager. | ||
Then reconnect the USB again, and load the additional USB drivers. | Then reconnect the USB again, and load the additional USB drivers. | ||
| − | |||
| − | |||
==== RS-232 ==== | ==== RS-232 ==== | ||
Revision as of 08:49, 23 January 2024
Required Windows drivers
Controlling the Hameg by USB requires installation of a specific windows driver provided by Rohde & Schwarz.
Conection methods
USB
The Hameg signal generator can be controlled by RadiMation by USB connection.
Note the following when setting up to control the Hameg by USB:
The device comes available as a separate 'HAMEG Measurement Devices' category in the Windows Device manager. It is necessary to enable the 'Load VCP' option of the driver in the Windows Device manager. Then reconnect the USB again, and load the additional USB drivers.
RS-232
The following communication settings can be used:
Baudrate: 4800
Data bits: 8
Parity: None
Stop bits: 1
Windows 11 support
The USB driver provided by R&S are not supported on Microsoft Windows 11 and newer, as an alternative the driver can be controlled using the RS232 communication method.
