Hameg communication

Required Windows drivers

Controlling the Hameg by USB requires installation of a specific windows driver provided by Rohde & Schwarz.

Conection methods

USB

The Hameg signal generator can be controlled by RadiMation by USB connection.

Note the following when setting up to control the Hameg by USB:

The device comes available as a separate 'HAMEG Measurement Devices' category in the Windows Device manager. It is necessary to enable the 'Load VCP' option of the driver in the Windows Device manager. Then reconnect the USB again, and load the additional USB drivers.

RS-232

The following communication settings can be used:

Baudrate: 4800

Data bits: 8

Parity: None

Stop bits: 1

Windows 11 support

The USB driver provided by R&S are not supported on Microsoft Windows 11 and newer, as an alternative the driver can be controlled using the RS232 communication method.