Difference between revisions of "Keysight Technologies N9038A General"
(Created page with "<!-- This page contains some general information of the Keysight Technologies N9038A that can be embedded on the all the N9038A pages --> The 'Advanced' configuration dial...") |
|||
Line 1: | Line 1: | ||
<!-- This page contains some general information of the [[Keysight Technologies N9038A]] that can be embedded on the all the N9038A pages --> | <!-- This page contains some general information of the [[Keysight Technologies N9038A]] that can be embedded on the all the N9038A pages --> | ||
+ | {{Warning|At least firmware version A.12.09 should be installed on the {{PAGENAME}}, otherwise the preamplifier cannot be controlled correctly in EMI receiver mode.}} | ||
+ | |||
The 'Advanced' configuration dialog of the {{PAGENAME}} device driver has several tabs to configure the device driver. | The 'Advanced' configuration dialog of the {{PAGENAME}} device driver has several tabs to configure the device driver. | ||
Revision as of 12:01, 9 June 2023
|
The 'Advanced' configuration dialog of the Keysight Technologies N9038A General device driver has several tabs to configure the device driver.
Settings
Select peak detector | Specifies the standard that should be used for the peak detector. Possible standards are: 'EMC Standard' or 'MIL Standard'. |
Select input | Specifies the input that should be used. Depending the exact model used, it is possible that the selection of the input is disabled. |
Use preselector | If the preselector should be enabled or not. |
Input
AC Coupling | Specifies that AC coupling of the input should be selected. |
DC Coupling | Specifies that DC coupling of the input should be selected. |
Has UKB Option | Specifies if the UKB option is present in the device, which will allow to perform measurements on a lower frequency range. |