|
|
(7 intermediate revisions by 4 users not shown) |
Line 1: |
Line 1: |
− | [[Image:Measurement Settings.PNG]] | + | #REDIRECT [[Chapter_14#7._Measurement_Settings]] |
− | = Measurement settings =
| |
− | With measurement settings you can change the behaviour of the at certain points. Be very careful what you do with these setting.
| |
− | | |
− | All settings done here are globally used inside RadiMation.
| |
− | | |
− | == Starting level signal generator ==
| |
− | With the starting level signal generator you can define the level on which RadiMation is setting the signal generator on at the start of a immunity test.
| |
− | | |
− | == Perform power delivery test after pause ==
| |
− | | |
− | == Disable frequency zoom-in in emission test ==
| |
− | Disable frequency zoom-in in emission test can be used to decrees the measuring time by not trying to pin point the most accurate frequency. Some labs are
| |
− | {{Warning|Disabling the zoom-in in emmission test in combination with analysers is very likely to result in wrong measurement. }}
| |
− | | |
− | == Calibration ==
| |
− | When using the calibration date for devices, you can specify the behaviour here. This may vary between a simple message untill stopping measurements being done.
| |
− | | |
− | = Required environment settings =
| |
− | With the required environment settings you can force the test engineer to fill in specific [[Environmental Data]] settings. The first test done with a new EUT document requires the engineer to fill in the requested information. The second time a button will appear that will fill in the same information as the previous time.
| |