Difference between revisions of "Measurement Settings"
(→Required environment settings) |
|||
| Line 19: | Line 19: | ||
= Required environment settings = | = Required environment settings = | ||
With the required environment settings you can force the test engineer to fill in specific [[Environmental Data]] settings. The first test done with a new EUT document requires the engineer to fill in the requested information. The second time a button will appear that will fill in the same information as the previous time. | With the required environment settings you can force the test engineer to fill in specific [[Environmental Data]] settings. The first test done with a new EUT document requires the engineer to fill in the requested information. The second time a button will appear that will fill in the same information as the previous time. | ||
| + | |||
| + | |||
| + | |||
| + | [[Category:RadiMation]] | ||
| + | [[Category:Configuration]] | ||
Revision as of 15:34, 4 January 2008
Contents
Measurement settings
With measurement settings you can change the behaviour of the at certain points. Be very careful what you do with these setting.
All settings done here are globally used inside RadiMation.
Starting level signal generator
With the starting level signal generator you can define the level on which RadiMation is setting the signal generator on at the start of a immunity test.
Perform power delivery test after pause
Disable frequency zoom-in in emission test
Disable frequency zoom-in in emission test can be used to decrees the measuring time by not trying to pin point the most accurate frequency. Some labs are
 |
|
Calibration
When using the calibration date for devices, you can specify the behaviour here. This may vary between a simple message untill stopping measurements being done.
Required environment settings
With the required environment settings you can force the test engineer to fill in specific Environmental Data settings. The first test done with a new EUT document requires the engineer to fill in the requested information. The second time a button will appear that will fill in the same information as the previous time.
