Difference between revisions of "Monitoring input channel setup"
(Created page with 'Monitoring input channel setup') |
|||
| Line 1: | Line 1: | ||
Monitoring input channel setup | Monitoring input channel setup | ||
| + | |||
| + | = General = | ||
| + | This setting window enables the end-user to configure the used AD-Converter during the test. | ||
| + | |||
| + | = Settings = | ||
| + | * Description. Here can the description of the device entered. | ||
| + | * Device. From the dropdown the used AD-Converter driver can be selected. | ||
| + | * Channel. Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels. | ||
| + | * Unit. Enter the unit corresponding to the values which will be retrieved from the device. | ||
| + | |||
| + | = Calculation = | ||
| + | |||
| + | = Measure = | ||
| + | |||
| + | = Range = | ||
| + | |||
| + | [[Category:RadiMation]] | ||
Revision as of 12:50, 16 October 2015
Monitoring input channel setup
Contents
General
This setting window enables the end-user to configure the used AD-Converter during the test.
Settings
- Description. Here can the description of the device entered.
- Device. From the dropdown the used AD-Converter driver can be selected.
- Channel. Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels.
- Unit. Enter the unit corresponding to the values which will be retrieved from the device.
