Difference between revisions of "Monitoring input channel setup"
(→Settings) |
|||
Line 5: | Line 5: | ||
= Settings = | = Settings = | ||
− | {{ScreenElementDescription|Description | + | {{ScreenElementDescription|Description|Here can the description of the device entered.}} |
− | + | {{ScreenElementDescription|Device| From the dropdown the used AD-Converter driver can be selected.}} | |
− | + | {{ScreenElementDescription|Channel| Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels.}} | |
− | + | {{ScreenElementDescription|Unit| Enter the unit corresponding to the values which will be retrieved from the device.}} | |
= Calculation = | = Calculation = |
Revision as of 12:53, 16 October 2015
Monitoring input channel setup
Contents
General
This setting window enables the end-user to configure the used AD-Converter during the test.
Settings
Description | Here can the description of the device entered. |
Device | From the dropdown the used AD-Converter driver can be selected. |
Unit | Enter the unit corresponding to the values which will be retrieved from the device. |