Difference between revisions of "Monitoring input channel setup"
(→Settings) |
|||
Line 11: | Line 11: | ||
= Settings = | = Settings = | ||
− | {{ScreenElementDescription|Description| | + | {{ScreenElementDescription|Description|Enter the description of the device. E.g. use the brand and/or identification number.}} |
{{ScreenElementDescription|Device| From the dropdown the used AD-Converter driver can be selected.}} | {{ScreenElementDescription|Device| From the dropdown the used AD-Converter driver can be selected.}} | ||
{{ScreenElementDescription|Channel| Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels.}} | {{ScreenElementDescription|Channel| Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels.}} |
Revision as of 13:00, 16 October 2015
Monitoring input channel setup
Contents
General
The Monitoring input channel setup window can be opened by opening a new or existing EUT file:
Then select the 'Monitoring input channels' panel. This window enables the end-user to configure the used AD-Converter during the test:
Settings
Description | Enter the description of the device. E.g. use the brand and/or identification number. |
Device | From the dropdown the used AD-Converter driver can be selected. |
Unit | Enter the unit corresponding to the values which will be retrieved from the device. |