Difference between revisions of "Monitoring input channel setup"
(→Calculation) |
(→Calculation) |
||
Line 20: | Line 20: | ||
[[Image:Monitoring input channel setup_calculation.png]] | [[Image:Monitoring input channel setup_calculation.png]] | ||
− | {{ScreenElementDescription|None|No further calculations are performed by RadiMation to the value the <b>device driver<b> is returning. }} | + | {{ScreenElementDescription|None|No further calculations are performed by RadiMation to the value the <b>device driver</b> is returning. }} |
{{ScreenElementDescription|Offset|RadiMation will apply an offset as entered by the end-user. }} | {{ScreenElementDescription|Offset|RadiMation will apply an offset as entered by the end-user. }} | ||
Revision as of 13:38, 16 October 2015
Monitoring input channel setup
Contents
General
The Monitoring input channel setup window can be opened by opening a new or existing EUT file:
Then select the 'Monitoring input channels' panel. This window enables the end-user to configure the used AD-Converter during the test:
Settings
Description | Enter the description of the device. E.g. use the brand and/or identification number. |
Device | From the dropdown the used AD-Converter driver can be selected. |
Unit | Enter the unit corresponding to the values which will be retrieved from the device. |
Calculation
None | No further calculations are performed by RadiMation to the value the device driver is returning. |
Offset | RadiMation will apply an offset as entered by the end-user. |