Difference between revisions of "Monitoring input channel setup"
(→Settings) |
|||
Line 16: | Line 16: | ||
{{ScreenElementDescription|Description|Enter the description of the device. E.g. use the brand and/or identification number.}} | {{ScreenElementDescription|Description|Enter the description of the device. E.g. use the brand and/or identification number.}} | ||
{{ScreenElementDescription|Device| From the dropdown the used AD-Converter driver can be selected.}} | {{ScreenElementDescription|Device| From the dropdown the used AD-Converter driver can be selected.}} | ||
− | {{ScreenElementDescription|Channel| Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels.}} | + | {{ScreenElementDescription|Channel| Based on the selected driver the amount of available channels are shown. In the past only eight channels were allowed. Older devices can still be limited to support a maximum of eight channels, while their driver supports more channels.}} |
{{ScreenElementDescription|Unit| Enter the unit corresponding to the values which will be retrieved from the device.}} | {{ScreenElementDescription|Unit| Enter the unit corresponding to the values which will be retrieved from the device.}} | ||
Revision as of 12:36, 6 November 2015
Monitoring input channel setup
Contents
General
The Monitoring input channel setup window can be opened by opening a new or existing EUT file:
Then select the 'Monitoring input channels' panel. This window enables the end-user to configure the used AD-Converter during the test:
Settings
Description | Enter the description of the device. E.g. use the brand and/or identification number. |
Device | From the dropdown the used AD-Converter driver can be selected. |
Unit | Enter the unit corresponding to the values which will be retrieved from the device. |
Calculation
None | RadiMation will not apply any additional calculations to the value the device driver is returning. |
Offset | RadiMation will additionally apply the specified offset to the retrieved value by the device driver. |
Multiply | RadiMation will additionally apply the specified multiply factor to the retrieved value by the device driver. |
AD input range | RadiMation will not apply any additional calculation to the value the device driver is returning. |
Formula y(x) | RadiMation will additionally apply the specified formula to the retrieved value by the device driver. |
It is needed to match the expected value with the retrieved value by the device driver. Especially for older device driver it is needed to specify the allowed value range of the device.