Difference between revisions of "Release Notes/Solved items Version 2022.2"
(Created page with "{{:Release Notes/Solved items Version 2022.2.1}}") |
|||
| Line 1: | Line 1: | ||
| + | {{:Release Notes/Solved items Version 2022.2.2}} | ||
{{:Release Notes/Solved items Version 2022.2.1}} | {{:Release Notes/Solved items Version 2022.2.1}} | ||
Revision as of 10:14, 28 September 2022
RadiMation version 2022.2.2
- #4601: Report, view and compare improvements for CAL files
- #5742: Determination of % out of 6dB error after UFA calculation
- #5936: Possibility to generate a report of a calibration with Report Generator
- #8586: Milmega 80RF1000-175 amplifier is not switching.
- #9626: Driver: ETS-Lindgren 2090
- #12686: Wrong test level if order is tick checkbox/change testlevel.
- #12765: Extend Uniform Field Area (UFA) calculation to include statistical information
- #12767: Calculate statistical information of UFA calculation.
- #12769: Show the result of statistical information of the UFA calculation on the UFA result window.
- #12770: Include report generator codes to include Statistical information in the report
- #12771: Update standard printout of UFA calculation to includes the calculated statistical information:
- #12861: Milmega 80RF1000 does not switch.
- #12957: The Note and Units buttons are not shown on the UFA result window.
- #12988: The maximum tolerance of the UFA calculation is not shown if it is all below the accepted tolerance
- #12989: Wrong unit is shown at maximum deviation frequency on printout of uniform field area calculation.
- #12996: Reading a binary block buffer results in a time out when using VISA Socket communication
- #12999: N9322C Fails
- #13000: N9322C Fails
- #13002: Remove code related to HP3478A from Fluke 8840 driver
- #13003: Show the number of device drivers on the RadiWiki website
- #13092: Can the QP detector value be shown in the peak table if the QP detector has been used in the measurement?
- #13094: Columns hidden from the detected peak table are still shown in the report
RadiMation version 2022.2.1
- #512: Ability of auto detection of all connected equipment
- #4517: Auto detect connected Radi-xxx equipment
- #5750: Improve the printout template of UFA calculation
- #6170: Add support for IEC 61000-4-16: conducted immunity: common mode disturbances in the frequency range 0 Hz to 150 kHz
- #6769: Improve detection of Radi-products
- #12766: Add report button to the calibration result window
- #12768: Add configuration options for the statistical information to the UFA calculation configuration dialog
- #12816: Attenuation gain system calibration does not report the calibration level when opening the .CAL file
- #12920: Switch to new text generation engine.
- #12948: The dropdown list with pre-filled tolerances is unlogical
- #12949: The red maximum error line in the UFA graph should be using the value as specified for the accepted tolerance
- #12950: Accepted extended tolerance should not be smaller than accepted tolerance
- #12951: Also include an 'Extended maximum error' graph to the UFA calculation graph
- #12952: Selected template and report filename are not remembered after report is generated for UFA
- #12954: A default filename and location for the report of a calibration file is not provided if the TSF file of the UFA calculation was not saved
- #12955: Unclear what the numbers on the UFA calculation result are indicating
- #12956: The maximum deviation of the UFA calculation is shown with too many digits
- #12958: Optimized UFA calculation drops unexpected points
