Difference between revisions of "Talk:RadiMation Application Note 106"
(Created page with '== Goal == To explain how the parameters of the powermeter configuration can be used to retrieve stable powermeter readings == Todo == # Include a screenshot of the powermeter p…') |
(→Todo) |
||
| Line 3: | Line 3: | ||
== Todo == | == Todo == | ||
| − | # Include a screenshot of the powermeter parameter settings | + | # V Include a screenshot of the powermeter parameter settings |
| − | # Explain the purpose of the possible parameters | + | # V Explain the purpose of the possible parameters |
| − | # Explain the different between levelling and monitoring | + | # V Explain the different between levelling and monitoring |
| − | # Explain tips and tricks on how to determine better measurement parameters | + | # V Explain tips and tricks on how to determine better measurement parameters |
| − | # Explain that the change is caused by the slowness of the powermeter but also by the slowness of the signal generator | + | # V Explain that the change is caused by the slowness of the powermeter but also by the slowness of the signal generator |
| − | # Include a picture of the Marconi power change when the carrier is changed, measured using the radipower envelope mode. | + | # ? Include a picture of the Marconi power change when the carrier is changed, measured using the radipower envelope mode. |
| − | #* Do a levelling test. Signal generator carrier going up and down a lot? => Too fast. Slow it down | + | # V * Do a levelling test. Signal generator carrier going up and down a lot? => Too fast. Slow it down |
| − | #* Slow measurements => Make it faster, but check (see at previous point) that it is not too fast | + | # V * Slow measurements => Make it faster, but check (see at previous point) that it is not too fast |
| − | #* Use the device specific input measurement to get 'internal' information of the levelling measurement in the powermeter | + | # * Use the device specific input measurement to get 'internal' information of the levelling measurement in the powermeter |
== discussion == | == discussion == | ||
* Should we also handle the same information for the fieldstrength sensor in the same application note, or should we create a separate application note for almost the same information for the fieldstrength sensor? | * Should we also handle the same information for the fieldstrength sensor in the same application note, or should we create a separate application note for almost the same information for the fieldstrength sensor? | ||
Revision as of 13:45, 13 March 2019
Goal
To explain how the parameters of the powermeter configuration can be used to retrieve stable powermeter readings
Todo
- V Include a screenshot of the powermeter parameter settings
- V Explain the purpose of the possible parameters
- V Explain the different between levelling and monitoring
- V Explain tips and tricks on how to determine better measurement parameters
- V Explain that the change is caused by the slowness of the powermeter but also by the slowness of the signal generator
- ? Include a picture of the Marconi power change when the carrier is changed, measured using the radipower envelope mode.
- V * Do a levelling test. Signal generator carrier going up and down a lot? => Too fast. Slow it down
- V * Slow measurements => Make it faster, but check (see at previous point) that it is not too fast
- * Use the device specific input measurement to get 'internal' information of the levelling measurement in the powermeter
discussion
- Should we also handle the same information for the fieldstrength sensor in the same application note, or should we create a separate application note for almost the same information for the fieldstrength sensor?
