Difference between revisions of "User:Jewe"
(→Signal generator driver test) |
|||
Line 29: | Line 29: | ||
# Set the PM to out of boundary settings, for example 0,1 Hz and 1%. | # Set the PM to out of boundary settings, for example 0,1 Hz and 1%. | ||
{{note|With all out of boundary settings an error must be generated.}} | {{note|With all out of boundary settings an error must be generated.}} | ||
+ | |||
+ | |||
+ | = Spectrum Analyser driver test = | ||
= Getting started = | = Getting started = | ||
== Philosophy == | == Philosophy == |
Revision as of 07:37, 31 August 2009
- make new getting started
Contents
Signal generator driver test
The following settings need to be tested:
Normal operation mode
- Amplitude
- Frequency
- AM, 80% 1 kHz
- FM
- PM 50% 1 KHz.
- AM external.
- FM external.
- PM external.
- Sine wave for amplitude modulation
- Square wave for amplitude modulation
|
Error operation mode
- unplug the communication cable during testing
- Set the AM to out of boundary settings, for example 0% or 1 MHz, this is not supported by the machine.
- Set the FM to out of boundary settings, for example 1 Hz or 1 MHz, this is not supported by the machine.
- Set the PM to out of boundary settings, for example 0,1 Hz and 1%.