Difference between revisions of "User:Jewe"
m (→Normal operation mode) |
m (→Normal operation mode) |
||
Line 36: | Line 36: | ||
==Normal operation mode== | ==Normal operation mode== | ||
+ | * Lowest frequency to 150 KHz, RBW 1 KHz. | ||
+ | * Lowest frequency to 150 KHz, RBW 9 KHz. | ||
+ | * 150 KHz to 30 MHZ with RBW 9 KHz. | ||
+ | * 150 KHz to 30 MHZ with RBW 1 KHz. | ||
+ | * 150 KHz to 30 MHZ with RBW 120 KHz. | ||
* 30 MHz to 1000 MHz with RBW 120 KHz. | * 30 MHz to 1000 MHz with RBW 120 KHz. | ||
* 30 MHz to 1000 MHz with RBW 9 KHz. | * 30 MHz to 1000 MHz with RBW 9 KHz. | ||
− | {{note|.}} | + | |
+ | {{note|All settings should be done with all the options of the machine, so Receiver/Analyser and FFT mode.}} | ||
==Error operation mode== | ==Error operation mode== |
Revision as of 08:43, 31 August 2009
- make new getting started
Contents
Signal generator driver test
The following settings need to be tested:
Normal operation mode
- Amplitude
- Frequency
- AM, 80% 1 kHz
- FM
- PM 50% 1 KHz.
- AM external.
- FM external.
- PM external.
- Sine wave for amplitude modulation
- Square wave for amplitude modulation
|
Error operation mode
- unplug the communication cable during testing
- Set the AM to out of boundary settings, for example 0% or 1 MHz, this is not supported by the machine.
- Set the FM to out of boundary settings, for example 1 Hz or 1 MHz, this is not supported by the machine.
- Set the PM to out of boundary settings, for example 0,1 Hz and 1%.
Spectrum analyser driver test
The following settings need to be tested:
Normal operation mode
- Lowest frequency to 150 KHz, RBW 1 KHz.
- Lowest frequency to 150 KHz, RBW 9 KHz.
- 150 KHz to 30 MHZ with RBW 9 KHz.
- 150 KHz to 30 MHZ with RBW 1 KHz.
- 150 KHz to 30 MHZ with RBW 120 KHz.
- 30 MHz to 1000 MHz with RBW 120 KHz.
- 30 MHz to 1000 MHz with RBW 9 KHz.
|