Release Notes/Solved items Version 2015.3.5
From RadiWiki
RadiMation version 2015.3.5
- #2848: Regulated testlevel should be above requested testlevel if testlevel could not be regulated within the tolerance
- #3962: A limit in a Multiband CI test is only checked when power is limited by amplifier limitation
- #3963: Ramp method in CI Multiband doesn't remeasure the generated voltage
- #4264: Field level is less than set
- #5371: Initialization of Prana AP32 DR216 Amplifier is always successful
- #5978: Driver: Prana DT70D Amplifier
- #5988: Driver Teseq ITS6006 for IEC61000-4-3 & CISPR11 as Signal Generator
- #6134: Driver: Teseq ITS6006 for IEC61000-4-3 & CISPR11 as Power meter
- #6214: Driver: Prana DP600 amplifier
- #6253: Driver: Prana DT70S amplifier
- #6288: Driver: Prana UX55 amplifier
- #6318: Driver: Prana SV70D amplfier
- #6319: Prana LT320D amplifier doesn't work
- #6358: RadiField and RadiGen doesn't switch to local at the end of a test
- #6374: Driver: Prana MT700 amplifier
- #6396: NI DAQ USB 6218 AD Converter read values are delayed
- #6425: Driver R&S NRP-Z91 controlled by SMB100A using USB
- #6460: Driver: Prana MT400 amplifier
- #6489: Check if the HI-6005 fieldprobe is working correctly in combination with the EPI1001A
- #6625: Driver: Frankonia EFS-10 / EFS-100
- #6641: Driver: Control the polarization on the antenna using an RadiCentre external relais card
- #6662: Virtual Instrument for the field strength sensor
- #6712: Switch the external 40 dB attenuator used with Keysight 33521B
- #6777: Amplifier Linearity / Uniformity test different result at 1 -6 GHz
- #6787: Agilent 4403B Spectrum analyser Device Not Connected error
- #6863: Explanation for the use of correction factors for a Current sensor
- #6864: DVDRSYS.DLL cannot be loaded anymore from new device drivers
- #6886: Driver: Bonn Elektronik BLMA 4060-40
- #6901: How to create a correction factor using the unit of transfer impedance in dBOhm
- #6909: Why is a window with a description and value text is shown during the test?
