Release Notes/Solved items Version 2017.1.6

RadiMation version 2017.1.6

• #4969: CANoe interface object not initialized correctly
• #7496: Sentinel dongle failure
• #7586: Not possible to export attached pictures in the report by using the Report Generator
• #7696: Graph is not showing (correct) trace data during CI calibration and RI Multiband
• #7829: Implement the AnalyserAsPowerMeterDecorator for ESU and ESI series powermeter device drivers
• #8062: Outside Points
• #8068: Marconi 2042: Specific System Error: 2
• #8165: Ability to use AM modulation with the obsolete Agilent Technologies E4432B Signal Generator
• #8287: Extend R&S ESCI driver to allow selection of CISPR-Average or (old-)Average as Average detector
• #8340: Ability of 'Power Measurement' settings for the R&S ESR7 to avoid unexpected bandwidth jump behavior
• #8378: Enabled Calibration before final measurements option causes GPIB: EABO timeout
• #8384: External reference setting of the R&S ZNB is changed during initialization
• #8403: Rotate to position after end of test (de-initialization)
• #8412: Ability of 'Power Measurement' settings for the R&S ESU40
• #8429: Opening of a very large CI Multiband test is very slow
• #8431: Unclear description when the RadiSense is still in standby
• #8444: Driver: BiDirectional Coupler BDC 0660-30/100
• #8446: Driver: Teseq CBA 1G-150 amplifier
• #8450: ESPC Not all bytes are written to the GPIB board "Perform short calibration before final measurement" option
• #8452: IFR 2052 driver is not working correctly
• #8467: RI Multiband AM modulation is only used for first point, after that its none if modulation conservation is activated
• #8477: RadiLog Error Report does not make screenshot from external monitor
• #8479: Maturo MCU raises a Lock error during deinitialization
• #8481: Driver: RSSA3021X Spectrum analyser
• #8483: R&S ESIB40: Function not available;FREQ:STOP:LINK START
• #8488: N9038A: System Error: -410: Query Interrupted
• #8493: CARAD software invalid messages received
• #8503: Marked peaks are not saved
• #8504: Minimum power of CI Fixed power test is -40 dBm
• #8508: Ability to select Internal or External reference clock on some devices
• #8510: Changing unit causes crash
• #8511: Frequency correction of PMM EP603
• #8512: Device Driver: Marconi 2052
• #8518: Not possible to generate a printout of the amplifier linearity test results
• #8523: Compression test table: uses wrong unit in time and frequency column
• #8526: Generated power of CWS500N1 drops at 350 kHz
• #8527: RSSML Merge reference source
• #8556: Negative power reading of NRP-Zxx powermeter
• #8557: Wrong de-initialisation NRP-Zxx
• #8573: Driver Antenna Schaffner Bilog
• #8584: Driver: PMM EP604
• #8602: Driver: Multimeter Agilent 34401A AC and DC measurement
• #8603: Driver: generic configurable coupler for the couplers of ATM Microwave
• #8604: Driver: generic configurable coupler for the couplers of RF Lambda