Release Notes/Solved items Version 2021.1.9

RadiMation version 2021.1.9

• #11666: ErrorReport: No Tooltip found for buttons placed on the graph control
• #11693: AW: Report Generator - keyword Frequency Step and Modulation does not work
• #11743: ErrorReport: "rbw coupling error" on HP 7405 analyser.
• #11746: ErrorReport: "Can't auto couple sweep time in zero span" on HP 7405 analyser.
• #11779: wxWidgets Debug Alert
• #11782: Driver: Teseq CBA 1G-600D.
• #11789: Editing a limit line value initially shows the unit default value scaled to the new selected unit
• #11790: VI instrument time index axis is not updated for the additional time measured
• #11791: Using SQL to format a custom peak table including frequency data adds the _RAW frequency column data instead.
• #11792: RadiTower unnecessary moved to 4M after measuring at 1m
• #11793: Error Start frequency is too low for selected equipment, when viewing the data of two tests simultaneously
• #11794: RI Graph, no filter at top of the Graph
• #11798: Graphs settings, Frequency Range/Scaling not possible.
• #11813: Cannot connect to Frankonia FC03 antenna tower controller
• #11816: Using order by clauses on table names results in the table not being found when the unit is missing in the keyword
• #11817: 0,5 kV is not selectable in the EFT manual mode test
• #11819: ESW8 Measuring input 2 @1 GHz results in error -222 data out of range
• #11820: Using a <CUSTOM> field in the EUTInfo.ini results in the input being shifted when shown in RadiMation
• #11826: During test initialisation a "Pause" window before action is not shown to the user
• #11832: limit lines is using a wrong x axis scale.
• #11833: Error report improvements.
• #11838: Device driver for Rohde&Schwarz SMBV100B Signal Generator
• #11839: Device driver for Rohde&Schwarz FSV3000 Spectrum Analyzer
• #11840: Incorrect step frequency in immunity.
• #11841: Peak number not visible in graph.
• #11849: Reporting of antenna height incorrect during test and in review
• #11852: Manual clamp mover driver is reporting the distance in degrees instead of centimeters
• #11853: Manual clamp mover driver shows the distance in on 0.001 mm accuracy, which is just unlogical
• #11859: RI logarithmic "Frequency Step" not possible to set smaler than 1%"
• #11863: Tooltip of shown peaks uses incorrect text, higher\lower then should be higher\lower than
• #11866: NSG4070 Does not power on at start of test.
• #11871: TESEQ NSG 3040: Device returned Error code: 19.
• #11872: NSG4070 failure?
• #11884: Number of peaks not correctly applied
• #11888: Peak detection absorbing clamp test
• #11889: Radilog becomes unresponsive and freezes Radimation, when monitor inputs are measured during MB Pulsed testing.
• #11890: ESW8 1000 kHz not possible with QP.
• #11878: Out of memory exception while doing EUT Save As...